Greenmaster compatible controller KXTL-230 KX8-230C JD-230 E/E FH058-H made in Italy

Availability: In stock

Regular Price: £176.00

Special Price £135.20

OR

Quick Overview

Motor controller board (made in EU) for treadmill  New, suitable to replace any type of controller (such as greenmaster jd-230e/e,KX8-230C JD-230-E 230 / E-FH058 H). Suitable for motors with rated voltage from 100 to 230V (regulate Vmax trimmer accordingly) and motor body diameter not exceeding 9 cm / 3,54 in. There is a fuse on the motor output in order to increase safety in the event of a short circuit of the MOSFET.

Universal Controller Board for Treadmill

Double click on above image to view full picture

Zoom Out
Zoom In

More Views

  • Universal Controller Board for Treadmill
  • Wiring
  • Potentiometer
  • universal treadmill controller wiring scheme (sample scheme for Greenmaster GMD controllers replacement)

Details

Technical Data


Pilot signal : 0-10 VDC , initial calibration 8 VDC = 170 VDC voltage to the motor.
Motor power supply ( terminals 3-4 ): 0 -230V , 8A max
Power display (terminals 12-16) : 0/12 VDC ( Terminal 16 = Zero ; Terminal 12 = +12 ), max 150 mA


Installation

It's advisable to add a fuse before feeding 220V AC and a filter network, if it's not already present on the treadmill .

Connect the terminals 1-2 to AC

Connect the motor to terminals 3-4 (in most cases, 3 on red M+, M- 4 on black )

Connect the power input terminals 12-16 of the console

Connect the output terminals 13-14-15 speed signal from console.

It's possible to connect the terminals 9-10 to safety key. Open circuit between 9:10 corresponds to STOP.

It's advisable to check that the absorption of the motor ( terminals 3-4) without user is less than 1.5 A and the absorption with user at 5 km/ h is less than 4A . If it's over those limits, you should check the transmission belt, the motor and the proper maintenance of the equipment.

The color scheme shown in the picture refers to the standard wiring for replacement of Greenmaster type controllers (Rogerblack, Energetics, Greenfit , Diadora, Reebok, Atala ).


Special Cases

If the console is not supported (does not give a linear signal) you can replace the console command with a potentiometer (image attached)

If the treadmill has a speed sensor, it should be connected directly to the relative signal cables of the console. In this case the speed control is performed by the console.

You may also be interested in the following product(s)

Controller Greenmaster | JD230F/F Round | New

Controller Greenmaster | JD230F/F Round | New

Regular Price: £240.00

Special Price £151.20

Controller Greenmaster | FH058W-H Square

Controller Greenmaster | FH058W-H Square

Regular Price: £216.00

Special Price £111.20

   

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

This site uses cookies. By continuing to browse this site you are agreeing to our use of cookies. Find out more here.
x