Motor compatible with Greenmaster DC Motor GMD82-06-2B, GMD95-06-1B and B1K051 (1,6hp) Diam.82

Availability: In stock

Regular Price: £285.00

Special Price £137.74

OR

Quick Overview

Treadmill motor compatible with Greenmaster DC Motor GMD82-06-2B, GMD95-06-1B and B1K051 (1,6hp) Diam.82 .



Please note that fixing holes may differ from your motor. If so, please adjust fixing plate or use jubilee clips for fixing.


Important note: Original motor manufacturer is out of business, only compatible motors from different manufacturers are available.

Y8E3807FP (for reference only a compatible motor will be supplied).

Double click on above image to view full picture

Zoom Out
Zoom In

More Views

  • greenmaster_dc_motor_gmd82-06-2b (for reference only a compatible motor will be supplied)
  • Dimensional sketch of supplied motor. Indicative measures, supplier specifications may vary without notice.

Details

Treadmill motor, DC. Compatible with Greenmaster DC Motor GMD82-06-2B, GMD95-06-1B and B1K051 (1,6hp) Diam.82

Installation
1. Check for proper lubrication of the running belt
2. Check the correct tensioning of the drive belt and running belt
3. Remove the old motor Connect the new motor ( Faston M + corresponds to the red wire M- corresponds to the black wire )

After installation, follow the instructions below to avoid damage to the motor as a replacement.

1. Regularly lubricate the running deck
2. Always start with your feet on the side rails (FIRST start the tape at 1km / h )
3. Keep a walking speed over 5km / h After training, check if the motor overheats .
4. If the motor reaches 45 ° C verify the correct installation and maintenance.

Special Cases
1. If the motor board does not have a speed sensor, it is necessary to calibrate the new engine. We proceed by turning the trimmer speed of 1/4 turn at a time as per the attached image
2. If the mounting holes do not match those on the treadmill, you can alternatively drill the mounting plate of the motor so that the holes match those on the engine or fix the engine with jubilee clips / metal bands (available from hardware stores).
3. If the engine crankcase touches the top of the treadmill, position spacer washers (available from hardware stores) under the hood to keep it slightly raised.

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

This site uses cookies. By continuing to browse this site you are agreeing to our use of cookies. Find out more here.
x