CHECK CONNECTIONS
         
(this cannot be done whilst thhe treadmill is switched on!)          
GUIDE BY PARTS FOR TREADMILL                  
WARNING! THIS ONLY APPLIES TO MACHINES THAT ARE SWITCHED OFF!            
                         
1. Disassemble the protective handrail on the right                  
                         
2. Open it to find the connection cable (see Fig.2)                  
                         
3. Verify that the cables are not damaged on the connection or close to it              
                         
  It is important that you can not see the copper wire under the plastic insulator.            
                         
4. Disconnect the cables coming out of the monitor from the ones that go to the motor area.          
                         
5. Ensure that all connecting pins are straight and not damaged (see Fig.5)              
                         
6. Reconnect the cables until you hear a click.                  
                         
7. Verify that the cables are not damaged by inserting them through the main upright (see Figure 7).          
                         
  Go back to MONITOR PROBLEMS Go back to START UP PROBLEMS            
  Go back to ERROR E1   Go back to TREADMILLS              
                         
  2. Connections       5. PIN CONNECTOR     7 CONNECTION IN THE UPRIGHT